一台德克磨床的英文资料---请教

老军工

Type 1
/ P2 X4 X. Y: C8 y0 @Flutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
) ]6 B  N2 |& w5 b) [/ Z6 [( ]Type 2
8 S/ c- ]1 m" q$ ]0 FFlutes with individual infeeds of depth have the same length ;therefore different points of exit at periphery.

- y' n$ e  @" o  v0 t3 u2 I& f8 s求助各位老师：本人是数控磨床操作工，

hyj_9766

用网络在线翻译

英德康

原帖由 老军工 于 2008-9-30 20:06 发表
0 H; N% M6 @7 F# m- KType 1
Flutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
  T; A' l# w7 }% f2 G/ t$ WType 2
Flutes with individual infeeds of depth have the same length ;t ...

老军工你好，对你的专业不熟，译文仅供参考，
第1类
: Q/ h1 f+ r) h' u# ]1 R- i7 y$ s* L对于个别横切深度的凹槽，长度不一样但刀边出位一样，
6 p3 S& G' Y; w- `2 @* U3 b0 r第二类，
$ v+ Q3 \1 a9 f+ Z  O6 I4 A对于个别横切深度的凹槽，长度一样但刀边出位不一样，