一台德克磨床的英文资料---请教

老军工

Type 1
Flutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
+ c: r  j  B: _3 @Type 2
Flutes with individual infeeds of depth have the same length ;therefore different points of exit at periphery.

8 o! R. \5 M; u$ B. ]求助各位老师：本人是数控磨床操作工，

hyj_9766

用网络在线翻译

英德康

原帖由 老军工 于 2008-9-30 20:06 发表
Type 1
  @/ L0 Y% m: w$ Y2 EFlutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
% F. l+ ]' v# tType 2
0 c" I% r" |, u( ]3 ^/ MFlutes with individual infeeds of depth have the same length ;t ...

老军工你好，对你的专业不熟，译文仅供参考，
  ~& n' E8 a* E5 H7 M# j" ^7 r第1类
对于个别横切深度的凹槽，长度不一样但刀边出位一样，
0 r1 B2 @2 a+ g" P/ z. {3 g第二类，
& m; M: c: j6 ]. p# r8 A* o对于个别横切深度的凹槽，长度一样但刀边出位不一样，