|
|
牧野机床出现以下问题，哪个大神帮忙解决。多谢了！1 O$ N( A$ o- r/ z1 j' d+ B7 Y: `
3 T; R5 G7 j8 N4 X* c
机床问题：" g% b k. N9 F U$ R- H
% ]0 X0 w/ o+ A+ ]% c
1、SPNDL SPEED COMMAND IS NOT SET WHEN START SW，WAS PRESSED
5 z' e- H& f$ \. y/ C8 t J' M; i2 Q9 D1 Z2 l) i
COMMAND S—CODE AFTER RESET ALARM0 J- m+ B3 v# f* X" D/ d
! M- W$ |" D2 ~& G5 |7 L8 q- @2、NOZZLE CLANT THERMAL RELAY IS TRIPPED' l3 O) _+ I: i
& G: _! R5 h. ^% l& ?5 L
DI SIGNAL TH2... WENT ON9 @- f7 s7 O8 ~0 i' D6 r1 W
& U6 b1 j% Q/ r
CHECK THERMAL RELAY AND THE BREAKER
$ _3 K1 E& s' D5 ]2 G. P. }4 A a9 ^8 m0 \& [& @) ~
3、NC ALAMRE IS BEING GENERATED) b% Y* u8 A! K- A: z
. Z0 _, r+ ?- q$ R; N4 x1 ]BMI SIGNAL AL....IS ON
! c& n" n& }$ w
: H% L5 O8 a" z7 n6 z! G% R, tCHECK FAULTY DEVICE
3 [: e% |8 {. \2 M: L& F3 U" g: V. R5 e! {. z& r0 R% \. t" W
4、TOOL CLAMP SIGNAL TOOK OFF DURING SPINDLE CW ROTATION DI SIGNAL LS00..IS OFF
# b- d+ T8 _: s9 P0 R" A, i/ A& c# P5 o1 C5 P, U! T
CHECK THE CONDITION OF LIMIT SWITCH，SILENOID AND ETC* c5 q! U B ^( k
5 d" M: A& r' _ C6 N- j( U
5、MAN. TOOL UNCLAMP & CLAMP CANNOT PERFORM AT AUTO MODE/ T1 D) o, |" x
6 r( K. ~8 g( y
SELECT CORRECT CODE6 S/ C) j5 W8 G9 R" `# ~* w
|
评分
-
查看全部评分
|
发表于 2015-7-30 16:52:32
