许可证制作是否正确？ 正确的话就是补丁程序没打好 按安装信息里把补丁程序重新打好 就ok了 我的就是这问题 按文件里的这个 步骤
' @: g/ d, ^# ~6 n1) Start pro/e setup
! R0 g) } T) X7 v; Y+ Q7 c: c
9 c) L' e6 O% m) c2) Open license.dat with any txt-editor and replace every occurance of 00-00-00-00-00-00 with your computer real HOST_D (same one shown in the bottom left corner of the Pro/e setup). Save the ptc_licfile.dat
: _- o+ d) O- V# {5 B3 K: w5 w1 {/ z
3) Install proe - proe_mech -ptc_distributed_services (optional). On license-config screen select "nodelocked license" and point to edited ptc_licfile.dat
9 v: b) t2 J, v4 @2 a4 a: B& ?3 E
0 J2 _5 J$ v# b* F7 N* `Next apply a patches (if u didn't install the complete package, you will get "File not found" errors, accept or bleed)7 Q: Y; w1 i7 `- T/ M/ E0 e& i
9 s/ V+ W. o1 {# Ifor pro/engineer:7 f: E8 D J% y7 t. `. y
Copy "proe_WF5_Win64_crk.exe" to folder <proeWildfire 5.0 progdir>\i486_nt\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"
4 x" S# ~- c9 ~& t0 g! |9 z: m6 Q! N' i1 z+ y
for pro/mechanica
7 T3 u4 f$ b u) ?2 xCopy "proe_mech_WF5_Win64_#1_crk.exe" to folder <proeWildfire 5.0 progdir>\mech\i486_nt\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"
2 w* R0 o/ C% vCopy "proe_mech_WF5_Win64_#2_crk.exe" to folder <proe mech WF5 progdir>\mech\i486_nt\ptc and click "Start > OK"
/ F( v- b2 Q& B) [( l# a, D7 U t- E
for ptc distributed services, b; n. n2 j- {8 U& R7 v
Copy "ptc_distributed_services_WF5_Win64_crk.exe" to folder <ptc_distributed_services WF5 Win64 progdir>\i486_nt\obj and click "Next > OK > Finish > OK"3 V% n/ C5 B5 L. d0 `4 k$ ?
& u& T6 g6 l* G5 f& S+ L" s7 h
That's all.. Enjoy  ) f9 N2 I; _8 T. R6 z' J
OK 刚刚解决掉 |
发表于 2012-5-10 09:57:22
