钻头加工，怎么处理这种铁屑？

七星龙渊

卧加还是立加啊？
: [1 R- \3 k2 q+ v- ]0 c4 c* I 7# cwenm

夕凡

不断屑阿，冷却压力提到30bar可以？越高约好
提高进给到0.4，降低线速度保证F不变，加工到120深停顿0.3S，这应该对节拍影响不打。
若还不行，观察钻头槽型是否利于断屑
GUHRING对于深孔钻很有研究和实际成功经验。

七星龙渊

Sandvik有10倍径以上的钻头吗？麻烦告诉一下型号。
16# xiaojunfang4

手扶拖拉基

要尊重科学，不要为了节拍而盲目提高切削参数。
4 |- Z  z3 F$ e" T6 [9 ^, a; P老学员 发表于 2009-5-17 21:50

7 i1 ^# n; ]$ k; g4 z% _# F
说的对

PLC电控单元

VC 设置到80   内冷加个 保证你搞定

城风

看看是不是钻头刃口倒棱太大了，

wangxinwu

建议选用可换刀片的钻头，刀片磨成群钻形式。

joseph8779

Since we do not know the detail of your drill we assume it is good for cutting A3 steel. We also had this problem before. Below is our solution: 1. drill a precise pilot hole, 2. increase your coolant pressure ( you can use high presssure coolant system), 3. selet a good drill for deep hole ( currently many tool makers have launched a similar type of drill like Mapal Mega Deep Drill (http://www.mapal.com/en/products ... ls/mega-deep-drill/), Walter Titex XD Bohrer drill and even OSG and Mitsubishi also developed this type of drill

512760995

提高进给